Skyjacker 7017 - Manual

#7017 STEERING STABILIZER
94-01 Models:
1. To install new steering stabilizer (#7017,
used with a drop pitman arm) insert a poly
bushing and a steel sleeve #54314 into each
eye of the stabilizer. Position poly boot onto
stabilizer and secure with tie strap provided.
2. To install piston end of stabilizer to the drag
link use the hardware furnished (see picture
#1): insert tapered sleeve into tapered hole
in the tie rod, place the small 1/2" washer on
the new 1/2” x 3 1/2" bolt and install through
drag link hole. Install the 5/8" spacer, the rod
end of steering stabilizer (with sleeve in the
eye), large 1/2" washer, and 1/2" self locking
nut onto bolt, and tighten (see picture #2).
3. At the frame end of steering stabilizer insert
the 1/2” x 4" long bolt through a washer, the
steering stabilizer, and the original mounting
tabs (with a provided spacer sleeve #54314
between original mounting tabs). Install as
shown in photo #3 - DO NOT install in origi-
nal mounting tabs for that tends to put down-
ward stress on drag link. Tighten nut.
#7017 Single Stabilizer
with Bracket
INSTALLATION INSTRUCTIONS
#I-7007/7017 (Rev. 10/02)
Picture #2
Picture #1
1
1/2 x 3 1/2” bolt
small 1 ¼
2
" washer
tapered
sleeve
drag link
5/8
sleeve
#54314
steering stabilizer
l arge 1/2”
washer
self locking nut
Picture #3
Dual Steering Stabilizer Available, #7217
1.
5/8 spacer
Arrow shows 5/8”
spacer