Spaulding Lighting Tempe Bollards - Fresno, Modesto or Tempe LED Retrofit - Manual

INSTALLATION INSTRUCTIONS
SAVE THESE INSTRUCTIONS
701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000 www.spaulding-ltg.com
WARNING! LUMINAIRES require high current and voltage. HID LAMPS used in luminaires generate intense light and high
temperatures. HID LAMPS may emit UV and IR radiation. LAMPS may contain MERCURY (Hg), LEAD (Pb) and other potentially
dangerous and/or toxic materials. If lamp is marked it contains mercury and is subject to disposal laws. See www.lamprecycle.org.
HID LAMPS may rupture unexpectedly.
WARNING! Fixtures must be grounded and installed in accordance with the National Electrical Code and all local codes. Failure to
do so may increase the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH. Install and use so lamp and control
gear burnouts do not cause a hazard and use only in environments for which the product is specifically marked.
WARNING! This product contains chemicals known to the State of California to cause cancer, birth defects, and/or other reproductive
harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
CAUTION! Follow ALL luminaire and lamp manufacturer's recommendations, product markings, instructions, restrictions and
warnings regarding lumninaire and lamp operation, burning position, cycling and lamp replacement. Luminaire label shows electrical,
environmental and lamp requirements.
STOP USING WHEN LAMP FAILS. Continued operation will result in control gear damage and
possible nuisance smoke.
All electrical work must be done by a qualified electrician.
Turn off electric power to all affected circuits and allow to cool before servicing.
A regularly scheduled maintenance program should be established to retain optimum light output and reduce heat retention. Dusting
with a soft, clean, dry cloth is normally sufficient for the reflector. Any accumulation of dust or dirt should be removed regularly from both
sides of the lens during relamping. Use only a mild soapy solution, DO NOT use alkaline or acid cleaners on reflector surfaces.
Carefully read these instructions before installing product. If you do not understand these instructions, before starting any work, contact
your Hubbell Lighting distributor or [email protected] or (864) 678-1000
Give instructions to facility owner/manager for future reference.
Hg
SYMMETRIC ASYMMETRIC
SQUARE UPGRADE KIT
SYMMETRIC
ROUND UPGRADE KIT
ASYMMETRIC