Spaulding Lighting Laramie LFL Accessories - Manual

Hubbell Lighting, Inc. Doc. No. 93023606
A subsidiary of Hubbell Incorporated Revision -
701 Millennium Drive • Greenville, SC 29607 Phone (864) 678-1000 Outdoor Lighting
®
FIGURE 1
VANDAL
SHIELD
SPACER
INSTALLATION INSTRUCTIONS FOR LARAMIE LFL
EXTERNAL ACCESSORIES
PREPARING DOOR FOR TOP VISOR (LFL-TVBZ)
1. Open Door. Loosen (2) Door Screws and swing Door out (See Fig. 1).
2. Remove (2) Retaining Washers and Remove Door.
3. Remove (2) Screws and (2) Clips in middle of door that retain the Lens (See Fig. 2).
4. Drill (2) .172” diameter holes through door using the cored holes in the casting.
5. Turn door over and drill (2) .172 diameter holes through door using drill points (See Fig. 3 & 4).
6. Replace (2) Screws and (2) Clips that retain the Lens.
7. Mount Visor (A) with (4) screws (B),
POLYCARBONATE VANDAL SHIELD (LFL-SPC)
1. The Vandal Shield Kit contains the following:
(4) Spacers
(4) Washers
(4) Screws
(1) Vandal Shield
2. Remove contact paper from Vandal Shield.
3. Mount Vandal shield to the Door with
Spacers, Washers, and Screws as shown in Fig. 5.
(2) DRILL POINTS FOR VISOR
AND FOR VANDAL SHIELD.
DRILL THROUGH DOOR.
(2) DRILL POINTS
FOR VANDAL SHIELD.
DRILL THRU DOOR.
(2) CLIPS HOLDING LENS
DRILL (2) .172" DIA. HOLES
THROUGH DOOR FOR VISOR.
VISOR
A SCREWS
B
DOOR
SCREWS
RETAINER
WASHERS
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 5
(2) CLIPS
HOLDING
LENS
DOOR
HINGE
PREPARING DOOR FOR INTERNAL LOUVER (LFL- IL)
1. Open Door. Loosen (2) Door Screws and swing Door out (See Fig. 1).
2. Remove (2) Screws and (2) Clips at end of door that retain the Lens.
(See Fig. 6).
3. Place Internal Louver (C) on top of lens with Louver flange at end of Lens.
4. Replace (2) Screws and (2) Clips to retain the Lens and the Internal Louver.
5. Close Door and tighten Door Screws.
SCREW
WASHER
FIGURE 6
LOUVER
FLANGE
C