SPYPOINT TINY - Manual (Page 22)

42 43
English
English
TEST
To set the camera or the distance. When “Test” mode is
selected, no picture or video is recorded. Walk perpendicularly
in front of the camera. When the camera detects movement,
the light winks to indicate that normally, a photo or video
would have been recorded. If the system does not detect
the movement, increase the distance detection using the
“Settings” menu (the option “Sensitivity” allows the user
to set the sensitivity to “High”, “Medium” or “Low”). You
can also realign the camera differently. Once you understand
how the device responds to detections, you can better adjust
the direction or the height of the camera (Recommended
installation height: less than 5 feet).
SETTINGS
To define the options of the camera. To configure the
system in English, hold the button “” until “Language” is
highlighted. Press “OK”, select “English” and confirm your
choice with “OK”. The system will change all the menus in
English by itself.
Time Start /
Time Stop: Allow the user to set the period of operation
of the camera. The start and stop time are
the hours during the camera is in action and
records pictures or videos. Example: if the
user selects a start time “7:00 am” and a stop
time “11:00 am”, the camera will only detect
for that period of time and will stay inactive
for the remaining hours. Press “OK” and use
“” or “” to adjust the hour. Press again “OK”
to set the minutes. When the time is properly
set, press once more “OK” to go back to
other settings.
For an activation of 24 hours, the same start
and stop time must be entered (example:
00:00 as start time and 00:00 as stop time.
These hours are the basic configuration of
your camera)
Note: The hours can be recorded over a
12 or 24 hours period. Refer to “Setting”/
“Time format” (00:00 means midnight)
Delay: Select the time interval between two photos
or videos.
Multi-shot: Take up to 6 consecutive shots at each
detection, with a 10 second delay between each
photo. This option allows up to 6 pictures
from different angles when the camera is in
“Photo” mode.
Video length: Allow the user to select the recording duration
when the camera is set in “Video” mode.
Language: Select a language for the camera’s menu.