SPYPOINT S-TINY-3 - Manual (Page 15)

28 29
English
English
Taking the SD card out of the camera and inserting it into the
computer port will achieve the same results. If no SD slot
is built into the computer, use a multi-card reader RD25-1
(sold separately, refer to the section "Options
" ).
VIEW
To view recorded photos or videos on TFT 2.4"
viewing camera screen or on a TV set at home.
• Viewing with the 2.4" screen: When camera is set to
"View", the last recorded photo or video recorded appears
on the screen automatically. Press "" or "" to view next or
previous images.
Press "OK" to view the different options available in "View"
mode.
View Date/Time: Allows the view of the date and time
printed on the picture.
Protect: To protect the photo or video on the
screen.
Erase one: To erase the photo or the video on the
screen.
Erase All: To erase all stored photos and videos,
with the exception of protected photos
and videos.
Format: To format memory card and to erase all
protected photos and videos.
Exit: To return to viewing screen.
Note: The number of yellow stars that appear to the right of
the screen corresponds to the resolution of the photos.

=Low (3MP)
 =Medium (5 MP)
 =High (10MP)
• Watching on TV: You can view the photos or videos
directly from a TV. Connect the yellow end of the audio-
video cable supplied into the "VIDEO IN" of the TV and the
other end into the "TV OUT" of the camera. The last photo
or video recorded appears on the screen automatically. Press
"" or "" to view next or previous images. The options are
the same as when viewing on the 2.4" screen (see above).
SOUND RECORDING
This SPYPOINT ® camera offers the possibility to record
the sound in " Video " mode. When the " Video " mode is
selected, the camera automatically records the sound. Under
the camera, you can find a rubber cap with the inscription
MIC. If the user does not want to record the sound, the rubber
cap needs to stay in place. If the sound recording is required,
the user must lift the rubber cap and turned it slightly so that
the microphone receiver is completely cleared (See figure
below).