Square Perfect 815 SP1 Light Kit - Manual (Page 8)

5. Remove the small black cap on the end
of the tripod stand (G) and insert the silver
end into the bracket on the boom stand
adaptor (D). Tighten the wingnut to lock
the adapter onto the tripod [figure 8].
6. Insert the boom (F) into the adaptor (D)
taking note that there are four diffrent
sizes of holes in the adaptor. Find the
hole that allows you to insert the boom
and tighten it down until it does not slip.
Once it is in place you can tighten it down
with the lever on the adaptor, and change
it’s pisition as needed for your purposes
(figure 9).
8
Copyright 2013 DTX International
Boomstand and Softbox Assembly Cont.
Figure 8
Figure 9
7. Add sand or weights to the counterweight bags (B) to
help balance the boom. Clip the counterweight to the
boom as shown in figure 10.
8. Now install the softbox to the end of the boom to
complete the assembly [figure 11]. Your boom stand is
now ready for use!
Figure 10
Figure 11