Stainless Works Chevy Camaro 6.2L 2010+ Exhaust - Manual

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183
2010+ CAMARO V8 CHAMBERED CATBACK INSTALLATION
INSTRUCTIONS
Thanks for purchasing a Stainless Works Chambered Catback Exhaust System for your
2010+ Camaro V8. We have gone to great pains to make sure that our exhaust systems
fit and sound great. Please follow these steps to ensure that your installation goes as
planned.
Disassembly
1. Disconnect battery.
2. Raise and support vehicle.
3. Remove (4) 15mm bolts holding cross brace on car.
4. Disconnect and remove rear O2 sensors. (only required when installing headers)
5. Remove exhaust behind the catalytic converters and retain the (2) clamps for use
on the Stainless Works Exhaust System. (Note these are not needed when
purchasing and installing headers with the catback for headers.)
Catback Installation
1. Install (2) clamps (previously removed) and lead pipes, using RTV high
temperature sealant.
2. Install (2) 3” clamps and X-pipe using sealant. Make certain that the X-pipe is
level in the tunnel, and pushed all the way forward. If necessary, you may need to
loosen the two bolts on each side which connect the factory cats to the manifold.
Once the front of the system is aligned properly, these can be retightened. This
step is often needed because the factory system is only 2.5” in dia., and this
sloppy connection may not be exactly aligned from the factory to allow fitment of
the larger 3” exhaust system.
3. Install (2) 3” clamps and chambers using sealant.
4. Install (2) 3” clamps and tailpipes using sealant.