Stainless Works Dodge Challenger RT 5.7L 2008-14 Exhaust User Manual
Stainless Works For the car
08+ CHALLENGER RT EXHAUST SYSTEM INSTALLATION
INSTRUCTIONS
Thanks for purchasing a Stainless Works exhaust system for your Challenger RT. We have tried
to include all the information you will need to install the exhaust system. Please contact us at
800-878-3635 if you have any questions.
1. Let car cool completely and exhaust cool to the touch before starting any work.
2. Remove the factory exhaust system starting at the rear of car. Be careful as the factory
system is very heavy and will need to be supported during removal.
3. Install x pipe and 2 clamps onto factory headpipes-the long legs of the x pipe will be the
outlet side of the x pipe-the short legs slip over the factory headpipes.
4. Install one clamp over each muffler inlet, and install mufflers onto x pipe outlet. The
muffler inlets will be 2 ½” inside diameter and are designed to slip OVER the x pipe
outlet. The hangers will need to be slipped over the muffler outlets-the left hanger for the
rear of the muffler is the one different style hanger-it looks like a tight “s” when viewed
from the rear of the car. A picture is below for clarity:
5. Slip two more clamps over the front tailpipes, and slip over muffler outlets. Install
hangers in respective positions. Install two clamps onto rear tailpipes, and slip over front
tailpipes outlets.
6. Install two hangers onto rear tailpipes and slide into place on rear tailpipes. A picture of
the drivers side is below: