Stainless Works Ford F-150 Ecoboost 2011-14 3.5L S-Tube Turbo Exhaust User Manual
Stainless Works For the car
WWW.STAINLESSWORKS.NET
800-878-3635
FAX: 440-543-9183
INSTALLATION INSTRUCTIONS FOR 2011+ F-150 3.5L V6
ECOBOOST 3.5” CATBACK EXHAUST
Thanks for purchasing A Stainless Works 3.5” Catback exhaust for your 2011+ F-150
Ecoboost. We have gone to great pains to make sure that our exhaust systems fit and
sound great. Please follow these steps to ensure that your installation goes as planned.
1. Stainless Works recommends the use of Hi-Temp RTV sensor safe silicon gasket
maker as an option to or in conjunction with the use of factory gaskets. The
recommended Oxygen Sensor Safe RTV is either Valco All-in-One Aluminum or
Permatex Copper P/N 101BR available at NAPA, Autozone and other retailers.
2. Disconnect the battery before starting work on the exhaust system for your
vehicle. Reconnect the battery when the job is completed.
3. Your exhaust system can be installed by a weekend warrior but the use of a lift is
recommended for ease of installation. If using a jack, the vehicle must be placed
on a level hard surface and jack stands are required for safety reasons.
4. You will assemble the components together as specified below, but only snug the
clamps as you move along from front to back. After aligning all the components
in the vehicle, you will tighten all the clamps working from front to back of the
vehicle.
5. Disconnect battery.
6. Raise and support vehicle.
7. Unbolt exhaust at 2-bolt flange (2) 10 mm bolts.
8. Unbolt first hanger on exhaust (2) 8 mm bolts.
9. Remove exhaust from hangers and remove from vehicle.