Stainless Works Ford F150 2010+ 5.4L-6.2L Catback - Manual

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183
2010+ FORD F-150 RAPTOR 5.4L and 6.2L SUPERCAB/
SUPERCREW CATBACK EXHAUST INSTALLATION
INSTRUCTIONS
Thanks for purchasing the Stainless Works Catback Exhaust for your 2010+ Ford F-150
Raptor 5.4L/ 6.2L Truck. We have gone to great pains to make sure that our exhaust
systems fit and sound great. Please follow these steps to ensure that your installation
goes as planned.
1. Stainless Works recommends the use of Hi-Temp RTV silicon gasket maker as an
option to or in conjunction with the use of factory gaskets. The recommended
RTV is Valco Sensor Safe Aluminum All in One or Permatex Sensor-Safe P/N
101BR or 27BR, available at NAPA and other retailers.
2. Disconnect the battery before starting work on the exhaust system for your
vehicle. Reconnect the battery when the job is completed.
3. Your exhaust system can be installed by a weekend warrior but the use of a lift is
recommended for ease of installation. If using a jack, the vehicle must be placed
on a level hard surface and jack stands are required for safety reasons. If using a
two post lift where the rear wheels hang fully, the rear axle must be jacked up
close to the original level position. This will make it much easier to assemble the
tailpipes as they come over the leaf spring.
4. Loosen clamp at slip fit connection point (behind the 2 bolt flange connection
point) and all clamps and hangers from this point to the rear of the vehicle.
5. Remove old exhaust from all hangers then remove from truck.
6. For the 5.4L only, move the factory hanger on the passenger side frame rail back
toward the rear of the truck approx. 3 inches to the next location and retighten in
place. See picture below, showing relocated hanger: