Reversing the door – Summit CM420ESBL User Manual

Page 8

Advertising
background image

screw hole plugs

door pin

lower hinge bracket

screw hole plug

screw hole plugs

door pin

lower hinge bracket

screw hole plug

English

7

Reversing the Door

1. Remove the top hinge cover screw and then remove the top hinge cover. (see

fig. # 1)

2. Using a Phillips Head Screwdriver, loosen and remove the screws holding the

top hinge in place. (see fig. # 1)

3. Remove the top hinge and carefully lift off the door.
4. Remove the screw hole plug from the opposite side and insert the plug in the

screw hole openings of the just removed screws. (see fig. # 2)

5. Remove the door pin from the bracket of the lower hinge by turning counter

clockwise. Move the pin to the opposite hole and tighten. (see fig. # 3)

6. Loosen the screws holding the lower hinge bracket and remove the hinge.

(see fig. # 3)

7. Align the holes in the lower hinge bracket to the corresponding holes in the

opposite side of the cabinet. Insert and tighten the screws.(see fig. # 3)

8. Align the bottom hole on the left side of the door.

9. Align the pin of the top hinge with top hole on the left side of the door and

push into place. Replace the screws in the upper hinge bracket but do not

tighten all the way. (see fig. # 2)

10. Make sure the door closes easily but forms a tight seal. Adjust the door as

needed. Once you are satisfied with the door alignment, completely tighten

the upper door hinge screws.

11. Replace the hinge cover, insert the screw and tighten completely.

(see fig. # 2)

12. If the door does not close properly, refer to the section titled “Door

Alignment”.

fig.2

fig.3

Advertising
This manual is related to the following products: