Summit FF41ESADA Series - Manual (Page 10)

DEFROSTING
The automatic defrost timer must be set prior to the operation of the refrigerator.
1. Plug the power cord into a 115 volt electric power outlet.
2. Set the timer to local time:
a. Using a pen or other similar nonconductive object, push the black button
and hold for three seconds until the LED illuminates.
b. Set the timer to local time by pushing the black button following the
instructions in the table below:
NOTE: This step must be completed within 10 seconds once the LED
illuminates.
Local
Time 1:00 -
2:59 3:00 -
4:59 5:00 -
6:59 7:00 -
8:59 9:00 -
10:59 11:00 -
12:59 13:00 -
14:59 15:00 -
16:59 17:00 -
18:59 19:00 -
20:59 21:00 -
22:59 23:00 -
0:59
Setting
Time
2:00 4:00 6:00 8:00 10:00 12:00 14:00 16:00 18:00 20:00 22:00 24:00
Switch
Pushing
Times
1 2 3 4 5 6 7 8 9 10 11 12
c. Once the time is set, the LED will blink the number of times the knob was
pushed.
Example: If the local time is 16:00 at the time of the installation, the following procedure
would be followed:
a. Push the black button and hold for three seconds until the LED
illuminates.
b. Then push the black button 8 consecutive times within 10 seconds.
c. Confirm that the LED blinks 8 times.
After the timer is set, the refrigerator will defrost automatically between 1:00AM and
4:00AM daily.
9