Summit FS20L - Manual (Page 4)

3
• This unit is not designed to operate in enclosed spaces. When placing your unit,
make sure you allow at least 4” of clearance on both sides, at the back and on the top.
Be sure that airflow under the appliance is not obstructed.
• Use two or more people to move and install the freezer. Failure to do so can result in back or
other injury.
• To ensure proper ventilation for the freezer, the front of the unit must be completely
unobstructed. Choose a well-ventilated area with temperatures above 60°F (16°C) and
below 90°F (32°C). This unit must be installed in an area protected from the elements, such
as wind, rain, water spray or drips, and away from direct sunlight.
• The freezer should not be located next to ovens, grills or other sources of high heat.
• The freezer must be installed with its electrical connection in accordance with state and local
codes. A standard electrical supply (115 V AC only, 60 Hz), properly grounded in
accordance with the National Electrical Code and local codes and ordinances is required.
• Do not kink or pinch the power supply cord of the freezer.
• The fuse (or circuit breaker) size should be 15 amperes.
• It is important for the freezer to be leveled in order to work properly. You may need to make
several adjustments to level it.
• In order to ensure normal operation of the freezer, after moving it a considerable distance,
you must wait for ½ to 1 hour before turning the unit on.
•
After an electrical failure, wait at least 5 minutes before turning on the freezer again or the
compressor may be damaged.
• This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
• IMPORTANT: Do not use mechanical devices or other means to accelerate the defrosting
process, other than those recommended by the manufacturer.
• IMPORTANT: Do not damage the refrigerant circuit.
• IMPORTANT: Do not use electrical appliances inside the appliance, unless they are of the
type recommended by the manufacturer.
• Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may
damage or discolor the interior.
• This freezer is best suited for medical and laboratory use. Do not use this apparatus for other
than its intended purpose.
If your electricity goes off, follow this procedure:
• Call your power company to see how long the power will be out.
•
If service is to be interrupted for less than 24 hours, keep freezer closed. This will help items
inside to stay frozen.
•
If service is to be interrupted for more than 24 hours, remove contents and store in another
freezer.
SAVE THESE INSTRUCTIONS