Summit SPD1205 - Manual (Page 6)

5
INSTALLATION INSTRUCTIONS
Before Using Your Appliance
1. Remove the exterior and interior packing.
2. Check to be sure you have all of the following parts:
4 leveling legs
2 wall-hanging brackets
2 wall-hanging hooks
2 plastic spacers
1 exhaust fitting
9 screws
1 Use & Care Guide
3. Allow at least 5 inches of space on all sides of the appliance.
4. Before drying, check all pockets. If nails or pins remain in pockets, they may
damage the dryer or clothes.
5. Put your laundry into the dryer evenly. Uneven laundry may cause noise or
vibration.
6. Never splash water on the control panel.
7. Plug the dryer into an exclusive, properly-installed grounded wall outlet. Do
not under any circumstances cut or remove the third (ground) prong from the
power cord. Any questions concerning power and/or grounding should be
directed toward a certified electrician or authorized Summit service center.
8. Make sure the dryer does not stand on its power cord.
Selecting a Location
Before you install the dryer, select a location keeping these considerations in
mind.
 If you plan to place the appliance directly on the floor, select a hard, level
surface. If the surface is uneven, see "Adjusting the Leveling Legs".
 Ventilation openings must not be obstructed by carpeting if you choose to
install the dryer on a carpeted floor.
 If you are going to wall-mount your dryer using the wall-mounting kit
(included), see "Wall-Mounting Instructions".
 Choose a site away from direct sunlight, which can affect the acrylic coating
as well as plastic and electrical components.
 Be sure there will be adequate ventilation.
 Room temperature should not fall below 32°F (0°C).
 The dryer should be kept away from sources of heat such as stoves, furnaces
or radiators.