Summit SCR1505 - Manual (Page 5)

SPECIAL CAUTIONS
 DO NOT step on the front louver panel of your unit or use it as a step.
 ONLY use polarized plugs to plug in your unit.
 DO NOT CUT OR REMOVE the ground connection on the electrical cable.
 CHECK that the electrical system is grounded BEFORE plugging in refrigerator for the first time.
 The polyurethane in your unit contains cyclopentane gas as a foaming agent. When repairing, DO
NOT use other types of polyurethane or mix the existing polyurethane with other types. SUMMIT is
not responsible for changes in the refrigerator if repairs are made by the user or unauthorized
technicians. Contact an authorized distributor for repair information.
 DO NOT place hands or other objects in the front louvers, rear grating or the fan guard while in
operation. This can cause personal injury and/or damage unit.
 BEFORE removing the front louver panel for maintenance and cleaning, DISCONNECT the unit’s
power supply to avoid accidents which may be caused by the oscillation of the blade of the fan motor.
 KEEP HANDS AWAY from door pivot when door is open.
 Before loading refrigerator, CHECK that shelves are fixed and have the number of supports indicated
for your model in the Instruction Manual.
 CHECK that the front louver panel and rear grating are in place before plugging in unit.
 DO NOT place chemical substances (solvents, reagents) or food in this refrigerator. This equipment
is intended for the storage and display of non-potentially hazardous bottled or canned products only.
 This equipment is intended to be located in the CONSUMER shopping areas of a retail FOOD store,
if the floor under the unit is maintained clean.
 DO NOT balance or tip unit at more than a 45° angle without the supervision of authorized personnel.
Severe injury can occur.
 DO NOT try to repair unit by yourself. Always consult your authorized distributor for service.
 BEFORE reporting a problem with your SUMMIT refrigerator, check the plug and fuses or circuit
breaker. If this is not the cause of the problem, call your distributor immediately so a technician can
be sent.
 The unit’s cooling capacity will decrease if:
– It is open for long periods,
– Excessive amounts of product are stored in it.
THIS WILL OVERLOAD UNIT AND INCREASE MALFUNCTION RISK.
5