Summit SEH1536 - Manual (Page 11)

E F
wood wall
Chimney Mounting
Plate
3.Fix the suspender screws.
Fix the screws to holes A and B.Keep a clearance of 5
mm (0.2") between wall and head of screws in order to
hang the hood body easily.Fix the chimney mounting
plate to holes E and F by using the screws provided with
hood.
4. Hang the range hood on the wall:
Hang the range hood on screws A and B, then tighten the screws securely. Fix two
screws into the C and D holes through the corresponding holes inside the hood.
Assemble flexible aluminum tubing to the plastic fitting on the hood. Connect the
other end of the tubing to the wall outlet. Assemble upper exhaust to lower
exhaust. Place both parts on the range hood. Screw lower exhaust to the body
using the side holes. Fix upper exhaust by using the holes on the side of exhaust
mounting plate fixed to holes E and F.
D C
10 13
WARNING!
Be sure the bulb is cool before trying to change it.
1
2
REPLACEMENT OF LIGHTING COMPONENTS
Disconnect the hood.
Remove the aluminum cassette filter.
In order to change the 50-watt halogen light bulb, refer to diagram below. (1) Press
down on the back part of the lamp holder and (2) turn it counter-clockwise.
Replace old bulb with new one. Turn in reverse direction when installing new bulb.
50-W Halogen bulb
Note: Replacement bulbs can be purchased directly from SUMMIT by calling us at
1-800-932-4267 or by going to our website at www.summitappliance.com/support.
Have the model number of your range hood handy.
MOVING THE HOOD
If you expect to have to move your range hood:
*
Keep original packaging. Move your hood using original packaging; comply
with moving instructions printed on the packaging.
If you do not have original packaging:
*
Do not put any load on the range hood.
* Avoid any possible impacts.
* Pack the hood in such a way as to prevent damage.