Sunnex HM2017-44 - Manual (Page 9)

Sunnex HM Light Service & Installation Manual 9
Sunnex Customer Service
Sunnex Inc, USA
+ 1 508 651 0009
Sunnex Equipment AB Sweden + 46 565 177 00
Warranty + 1 508 651 0009
Guidance and manufacturer’s declaration — electromagnetic emissions
The HM LIGHT is intended for use in the electromagnetic environment specified below. The
customer or the user of the HM LIGHT should assure that it is used in such an environment.
Emissions test Compliance Electromagnetic environment — guidance
Emissions test
CISPR 15
Complies
HM LIGHT may not be interconnected with other
electrical equipment.
Harmonic
emissions
IEC 61000-3-2
Not applicable
Voltage
fluctuations/ flicker
emissions
IEC 61000-3-3
.
Not applicable
The HM LIGHT is suitable for use in all establishments,
including domestic establishments and those directly
connected to the public low-voltage power supply
network that supplies buildings used for domestic
purposes.
Guidance and manufacturer’s declaration — electromagnetic immunity
The HM LIGHT Image Intensifier is intended for use In the electromagnetic environment specified below. The
customer or the user of the HM LIGHT Image Intensifier should assure that it is used in such an environment.
Immunity test
lEC 60601
test level Compliance
level Electromagnetic environment —
guidance
Electrostatic discharge
(ESD)
lEC 61000-4.2
±6 kV contact
±8 kV air ±6 kV contact
±8 kV air
Floors should be wood, concrete or
ceramic tile, If floors are covered with
synthetic material, the relative humidity
should be at least 30 %.
Electrical fast
transient/burst
lEC 61000-4-4
±2 kV for power
supply lines ±2 kV for power
supply lines
Surge
lEC 61000-4-5 ±1 kV differential
mode
±2 kV common
mode ±1 kV differential
mode
±2 kV common
mode
Mains power quality should be that of a
typical commercial or hospital
environment.
Voltage dips, short
Interruptions and
voltage variations on
power supply Input lines
IEC 61000-4-11 <5 % U
T
(>95 %
dip In U
T
) for 0,5
cycle
40 % U
T
(60 % dip in U
T
)
<5 % U
T
(>95 %
dip In UT) for 0.5
cycle
40 % U
T
(60 % dip in U
T
)
Mains power quality should be that of a
typical commercial or hospital
environment, If the user of the HM LIGHT
Image Intensifier requires continued
operation during power mains
Interruptions, It is recommended that the