Swiss+Tech Transformer Xi 12-In-1 - Manual

Patent pendings. Made in China.
SWISS+TECH ® is a registered trademark, and
First in Key Ring Products™ and Transformer™
are trademarks of Crestwood Partners, LLC.
© 2008 Crestwood Partners, LLC
Cleveland, OH 44143 1-800-414-8799
#74030 Rev. A
Transformer™ Xi 1 Xi 12-in-1 Using the 12-in-1 1 12- 2-in in--1 Batt 1 Batter ery R y Replacement eplacement
Transformer™ 12-in-1 ships with both the
FLASHLIGHT and WORK LIGHT Switches in
the Off Position. With both switches in the
Off Position, the switch that slides TOWARD
the Flashlight turns ON the Flashlight, while
the switch that slides TOWARD the Work
Lights turns ON the Work Lights.
To use one of the SIX SCREWDRIVERS, press
with your thumb on the “TECH” end of the
SWISS+TECH
® logo to push out the Middle
Screwdriver Compartment. Rotate the Middle
Screwdriver Compartment out 180 degrees
until it locks into place. This automatically
releases the Transformer™ 12-in-1 from the
Key Ring. Select one of the six screwdrivers
and rotate it out 180 degrees until it snaps
in place. To close, follow these instructions in
reverse. Be sure to hook the Key Ring while
closing the Middle Screwdriver Compartment.
12-in-1 Battery Replacement
2. 2. Remove old batteries.
3. 3. Replace with two new CR1025 3V lithium
batteries or equivalent, taking care to place
the positive (+
+) or negative (–) side up as
indicated.
4. 4. Replace the Switch Assembly by first
inserting the tabbed end into the slot.
Replace the screw turning clockwise with a
small Phillips screwdriver. Tighten gently.
DO NOT dispose of batteries in fire,
batteries may explode or leak.
Work
Lights
Flashlight
Work Lights ON
Flashlight ON
Middle
Screwdriver
Compartment Quick
Release
Key
Ring
1 1.. The batteries for the flashlight and work
lights are under their On/Off switches.
Using a small Phillips screwdriver, turn
counterclockwise to remove the screw next
to the switch that needs new batteries.
Gently lift the Switch Assembly up and out
to expose the Battery Compartment.
(–)
(+ +)
Tabbed
End
6 Swing-Out Screwdrivers:
#0, #1, #2 Flat & Phillips
Dual
Work Lights
Straight Edge
5 mm Marks
1/4 inch Marks