TapeTech 76TT EasyClean - Manual (Page 2)

Operation and Maintenance Guide
1380 Beverage Drive, Suite W
Stone Mountain, GA 30083
1-800-426-6256 | 770-243-2323
Better – Faster – Every time
Updated 01 2014 © 2014 TapeTech Tool Co. All Rights Reserved
www.tapetech.com
Operation
With its two nozzles, the EasyClean™ Pump fills nail spotters, automatic tapers, flat boxes,
corner applicators and the MudRunner®
The filler attachment is secured to the EasyClean™ Pump by aligning the slots of the filler
over the studs on the EasyClean™ Pump housing and tightening the two hex nuts. There
is no additional gasket required between the EasyClean™ Pump and the filler .
Place the EasyClean™ Pump in a standard five gallon bucket, making sure the joint
compound is well mixed and free of lumps. A new or freshly cleaned EasyClean™ Pump
should be primed before use by pouring 1/2 cup (100 ml) of water into the outlet.
Once the EasyClean™ Pump is full of joint compound, no further priming is needed.
Maintenance
The EasyClean™ Pump can be disassembled by disengaging the two clasps at the top of the EasyClean®
Pump and pulling the barrel away from the main EasyClean™ Pump body. The plunger can then be
removed by disengaging the quick release pin and sliding the plunger through the EasyClean™ Pump
housing.
The foot valve can be removed by twisting and pulling the valve down and away from the cylinder.
The EasyClean™ Pump can now be cleaned by using a water hose or water and a brush to remove the
joint compound from the EasyClean® Pump housing and plunger. Then, after the tool is clean, lightly
oil with Ames® Bazooka® Oil or any light machine oil. To keep your EasyClean™ Pump in top working
order, you may need to replace the screen and o-rings on your EasyClean™ Pump. These items should
be checked when you clean your EasyClean™ Pump.
Common Wear Parts
Screen (Fine): 700032F
Screen (Coarse): 700033F
O-Ring: 729071
O-Ring: 729072
O-Ring: 709034
These wear parts are available as a maintenance kit - Model 501J.
EasyClean™ Pump & Filler Adapter
Models: 76TT (Pump) & 90T (Filler)