TapeTech 8142TT Finishing Box Handle - Manual (Page 2)

Operation and Maintenance Guide
1380 Beverage Drive, Suite W
Stone Mountain, GA 30083
1-800-426-6256 | 678-892-2323
Better – Faster – Every time
Updated 04 2012 © 2012 TapeTech Tool Co. All Rights Reserved
www.tapetech.com
Operation
The finishing box is controlled by specially designed handles,
ranging from 34” to 72” (1-2 m), allowing heights of up to 12’
(4 m) to be finished from the floor. The handle is attached to the finishing
box by sliding the box onto the handle and tightening the wing nuts securely.
There are only two adjustments on the finishing box handle. First is the set screw in the pivot
arm, which may be screwed in or out to adjust the width of the brake locking handle. Next is the
aluminum ball on the handle which may be moved up or down the handle to ease operation of
the finishing box.
Maintenance
Clean thoroughly with brush and water (or water hose) to remove all joint compound from the tool.
Then, after the tool is clean, lightly oil with Ames® Bazooka® Oil or any light machine oil.
Finishing Box Handles
Models: 8034TT, 8042TT, 8054TT, 8072TT, 8134TT, 8142TT, 8154TT, 8172TT