Telematrix 3300 Series - Manual (Page 4)

3
Calling...
Placing a Call Using the Handset - # 1
• Lift the handset.
• Dial out by using the numeric dial pad or by pressing a speed dial location.
Receiving a Call Using the Handset or Speaker - # 1 & # 15
• On a single line telephone, when the phone rings, either lift the handset or press the
speaker key should you have a speakerphone, to begin the conversation.
• On a two line telephone, when the phone rings, the line LED indicator will blink to show
which line the call is coming in on. Select the blinking line key, then lift the handset or
press the speaker key should you have a speakerphone, to begin the conversation.
Placing a Call Using the Speakerphone - # 15
The 3300 Series speakerphones are equipped with a high quality speakerphone feature
to allow hands free operation. To use, simply press the “Speaker” key when placing or
answering a call. The telephone line will activate automatically. The “Speaker” key will
light up indicating that the speakerphone is in-use. To hang up, press the “Speaker”
key again.
(Does not apply to non-speakerphone telephones)
Programming...
To program Store # 5, Flash # 6 & # 14, and Pause # 12
Some of these programming keys are located under the faceplate and overlay, begin by
lifting up faceplate and overlay, by either a paperclip or sharp pointer.
Storing a Number Into Memory Keys - Store # 5
Each location can store up to 32 digits in tone mode.
Note: a “Pause” or “Flash” programmed into memory counts as one digit
when storing a number.
1. Lift the Handset.
2. Press the STORE Key - # 5.
3. Enter the number to be stored using the numeric dial pad.
4. Press the desired memory location wherein the number is to be stored.
5. If additional numbers are to be stored, repeat steps 3 thru 5.
6. Hang up the Handset.
(Does not apply to non-memory key telephones)
Programming Flash Timing & Pause Timing
Flash timing options are 100mS thru 1000mS, programmable in 100mS increments. The
default Flash timing is 600mS.
Pause timing options are 1.0 sec. thru 5.0 seconds. The default Pause timing is 3.6 sec.
1. Lift the Handset (off-hook position).
2. Press the “Store” key once - # 5.
3. Program “Flash” by pressing “1” for 100mS, “2” for 200mS, etc.... # 6 & 14
4. Exit programming by hanging up the handset.
To program Pause follow the above sets, except at # 3 - do the following:
3. Programming “Pause” by pressing “1” for 1.0 sec., “2” for 2.0 sec., etc... # 12