Telematrix SP300 - Manual (Page 14)

14
Wall Mounting the Spectrum PLUS TM Telephone
To install the wedge for desk mounting, be sure the lock mechanism is positioned to the left
clear of the locking arm. Place the wedge in the slots, wide end toward top of phone base
unit, and slide the wedge upward into position. Lock the wedge into place.
Desk Mounting
2. The Spectrum PLUS TM has provisions for a
mounting wedge that must be correctly positioned.
This wedge allows the telephone to be viewed at a
correct angle when the phone is wall mounted.
Remove the wedge from the phone base (figure 2).
3. Secure the line cord, coil cord and any wiring in
place prior to installing the wall mount wedge. The
wall mount base has extra large wiring channels
and strain relief poles for containing the wires in a
neat and orderly way. Wrap the wires around the
strain relief poles and then secure the wires
through the channel.
4. To wall mount, place the narrow edge at the top
edge of the phone base and slide the wedge up-
ward into place (figure 3).
5. Lock the wall mount into position by sliding the
locking button to the right (figure 4).
Note: A 6-inch line cord is provided for when
the telephone is to be wall mounted. Connect
one end of the line cord to the phone jack and
the other end to the wall jack. Be sure to con-
nect the power cord and line cords before plac-
ing mounting wedge on the bottom base. An
optional coaxial power supply can be used in
place of the supplied power supply. See your
local distributor for information.
!
figure 2
Replace Mounting Wedge
figure3
Replace Mounting Wedge
figure 4
Lock Mounting Wedge
The Spectrum PLUS TM was designed to be
conveniently wall mounted without requiring
additional hardware.
Follow these easy steps:
1.The handset retaining clip must be in the correct
position to secure the handset into the handset
cradle. Engage the clip with your fingers and pull
the clip forward (towards you), rotate the clip 180º
and snap the clip back into place (figure 1). The
retaining clip cannot be removed.
RETAINER CLIP
figure 1
1. U N S NA P
2. R O TAT E 1 80 .
3. SN AP I NT O P LA C E.
NOTE: CLIP IS
1.LIFT CLIP OUT WITH
FINGERS. IT CANNOT BE
REMOVED BECAUSE IT
IS SPRING LOADED.
2. ROTATE THE
CLIP 180
0 AND
IT WILL SMAP
BACK INTO THE OPPO-
SITE POSITION. AN