TerraWave TW-HC-1142A - Manual (Page 4)

TerraWave Solutions
®
802.11n MIMO 18”x 18” x 1.5” Hard Cap Ceiling Enclosure
Installation Instructions (continued)
Version 2.0
www.terrawave.com Email: [email protected] Phone: 210-375-8482 or 800-851-4965 10521 Gulfdale, San Antonio, TX 78216
For detailed product information and to purchase product, please contact a TerraWave
wireless networking solutions sales engineer at 210-375-8482, 800-851-4965,
[email protected] or visit
www.terrawave.com .
TerraWave is the primary manufacturer in the
industry to offer such cutting-edge products
for wireless networking deployments.
Installing the AP into the Enclosure
1. Attach the Cisco AP to the enclosure mounting plate (Figure 7) by aligning the AP mounting feet with the keyholes
provided in the mounting plate (Figure 8). Slide the AP down and the AP will lock onto the mounting plate when it is
secure (Figure 9). You will not need the mounting plate that ships with the Cisco AP.
2. Complete the power and Ethernet connections according to the manufacturer’s instructions by feeding the cables
through the hole in the enclosure mounting plate (Figure 10).
3. Place the enclosure mounting plate, with the access point attached, into the opening in the enclosure by sliding the
long end (opposite the cable connections) into the enclosure at an angle of approximately 30 degrees (Figure11).
Lower the opposite end of the mounting plate into the enclosure, making sure the cables do not bind or crimp (Figure
12).
4. Turn the locking mechanism to secure the access point.
Figure 7 Figure 9
Figure 11 Figure 12
Figure 8
Figure 10