Therasage Portable Sauna - Manual (Page 4)

The Elite Task Office Chair
With Far Infrared Heat
The Elite Task Office Chair
With Far Infrared Heat
The Elite Task Office Chair
With Far Infrared Heat
INSTRUCTIONS FOR ASSEMBLY, CLEANING AND STORAGE
Prior to using your Sauna for the first time, check to insure that all the parts are included in your
shipping box.
Parts List:
A. One contiguous frame of side walls and back wall, the interior of which has heating elements
and TheraDisk™ panels
B. Electronic control box attached to the back panel
C. Controller – for heat and time
D. Folding Chair
E. Foam Floor Cushion
F. Frame Cross Bar
G. Two terrycloth collars
Keep all sharp objects away from the sauna as they may cause damage. This product contains an
electrical component which if punctured or tampered with could cause damage or injury.
To Assemble:
Step One: Unfold both side walls of the Sauna so it stands upright.
Step Two: Close the zipper from the bottom of the back wall to the front end.
Step Three: Place the foam floor cushion in place, glossy side facing upward.
Step Four: Place the folding chair on the floor cushion near the rear of the unit.
Step Five: Plug electrical power cord into a standard outlet. Your Sauna is ready for controller
operation and use.
TO CLEAN, FOLD AND STORE
Open the zipper to ventilate and cool. After each use, remove any condensation or perspiration from
the chair and the interior of the unit with a clean damp cloth. Do not use any cleaning agents or
solvents. The removable terrycloth collar may be machine washed separately in warm water.
After the Sauna has been wiped off and is fully cooled, simply reverse the steps above to fold for
storage. If left assembled, unplug the power cord after each use.