Therma-Tru SHOP 2 Equipment and Facilities - U1 Revised - Manual (Page 3)

Equipment
and Facilities
Shop 2 2014 (U1 REVISED) 2.3
Equipment
Below is a recommended list of equipment required for a millwork shop.
Air Compressor
Assembly Tables (see sketches on following pages)
Caulking Guns (manual or air-powered)
Drill Press (optional)
Miter Saw
Power Drill
Radial-Arm Saw
Screw Guns with torque-adjustable clutch
Shop Hand Tools - hammer, chisel, etc.
Staple Guns (various sizes)
Table Saw (sliding table preferred)
6SHFLDOSXUSRVHPDFKLQHU\ H[.9$/1RU¿HOG
- Jamb lock preparation
- Jamb hinge preparation
- Door lite cutout (RUVO/Triad machines available from Therma-Tru)
- Door lock preparation
- Door edge planing and beveling