Trim-Tex Regular and Bullnose L Beads - Manual

Please read entire instructions before beginning.
1. Precut all parts to fit the return. Leave 1/16" clearance on ends. To use prescored
marks, back bend at the desired score mark several times and then tear off the strip.
The strips are sometimes hard to tear because the prescored marks must be invisible
from the top of the piece. When this is the case,
pair of
pliers may be helpful to tear the piece. Slip on Finish Trim. (If used) Use Trim-Tex Miter
Marker (# 0932) for mitering 90° and 135º corners on Bullnose Super & Giant L’s.
2. Apply 2 or 3 beads of Trim-Tex's
or Liquid Nail, onto
return for full coverage. Make sure adhesive covers finish trim. (If used)
3. Align L Bead onto return and press firmly into place. Staple mud flange to wall.
4. Adjust Finish Trim to fit tight against window frame.
5. Always extend Archway L’s beyond the arch approximately 16 inches onto the
straight area where there is sufficient backing material to allow the butt joint to be
properly adhered and to provide a flat surface for floating the butt joint.
6. Before painting, float and tape all straight butt joints, caulk corner joints and caulk
along the window frame.
run a knife down the score line. A
#700/710 Adhesive Caulk
INSTALLATION INSTRUCTIONS
FOR REGULAR AND BULLNOSE
SUPER, GIANT, OVERSIZED,
AND ARCH L BEADS
FULL COVERAGE OF TRIM-TEX'S
DHESIVE CAULK #700/710 A /
TT-202A
INC.
Caulk
Float In
D RY WA L L P R O D U C T S
F
OR
U
LTIMATE
A
DHESION USE
T
RIM
-T
EX
'
S
#700/710 A
DHESIVE
/C
AULK