Trim-Tex Niche Bead - Manual

INC.
Niche Bead
Installation Instructions
3700 W. Pratt Ave. Lincolnwood, IL 60712-2508 Phone: (847) 679-3000 Fax: (847) 679-3017 www.trim-tex.com
Step 1 : Set the drywall back / " and dry fit a
small sample piece of the Niche Bead for an
accurate installation .
5 8 Step 2 : For precise miters cut a support block 1 / " x 1 / ". Always wear safety glasses when
using miter saws, staple guns, or spray adhesive. To ensure accuracy, make the miter cuts
slowly. Typically a 90º inside or outside corner will require setting the miter saw to 45º. Most
corners are rarely a true 90º so you may need to adjust the angle and make some practice
cuts first.
3 4 3 4
Step 3 : Snip back the mud legs up to the mud
bump to prevent overlapping of beads. Install
the bead with
" divergent staples every 6"
and Trim-Tex 847 Spray Adhesive. Place a
bead of adhesive caulk (Trim-Tex 710
Adhesive Caulk) at the seam and wipe away
the excess caulk.
NO ADAPTERS needed when joining an
outside or inside Trim-Tex
corner bead.
Simply snip back the mud legs and install as
previously stated.
½
90 º Outside Corner
Bead
Support
Block
45º Miter for
inside or outside
corners.
SMOOTH TRANSITION TO ANY CORNER
Splayed Outside Corner
Bead
90 º Inside Corner
Bead
90 º Inside Corner
Bead
Splayed Outside Corner
Bead
Adjustable In side Corner
Bead
SHARP LOOK WITHOUT ANY ADAPTERS
64110
Please read entire instruction
before proceeding.
Improper installation will void any applicable warranty.
© Copyright 2009 Trim-Tex Inc. All Rights Reserved