Belkin F8D0502 - Manual (Page 4)

Removing the Thumb Keyboard Software
3
Installing Thumb Keyboard to your Axim
4
Follow these instructions if you want to remove the Thumb
Keyboard software from your Axim:
1. Close all active windows on your Axim.
2. Go to the “Remove Programs” settings page under the “System”
section in the ”Settings” menu.
3. Select “BelkinThumbBoard” and then tap “Remove”.
4. Tap “Yes” in response to the “Remove Program” dialog in confirming
the removal of the software.
Note: Make sure you have reinstalled the software before using the
Thumb Keyboard again.
Reinstalling or Upgrading the Thumb Keyboard Software
To reinstall or upgrade the Thumb Keyboard software, you must first
remove the existing software by following the steps outlined above.
Then follow the steps outlined in the “Software Installation” section.
Attaching the Thumb Keyboard to your Axim
1. Hold your Axim face up in the palm of one hand and the Thumb
Keyboard face up in the other hand.
2. Slide your Axim into the Thumb Keyboard until the connector
latches securely.
Detaching the Thumb Keyboard from your Axim
1. Hold your Axim face up in the palm of one hand.
2. Press the release buttons on both sides of the Thumb Keyboard to
release the connector lock.
3. Remove the Axim by sliding away from the Thumb Keyboard.
Charging your Axim with the Thumb Keyboard
The Thumb Keyboard includes a DC jack on the bottom. To charge
your Axim, just insert the AC adapter plug into the DC jack of the
Thumb Keyboard.