TruXedo Toyota Tundra Stepside - Manual

P/N 1115452 Rev. D
truxedo ® lo pro tundra step side clamp/adapter pan instructions
Read your owner’s manual and these instructions before installing
your Toyota Tundra Truxedo ® Lo Pro kit.
Follow these instructions to install your TruXedo ® Lo Pro side rail
clamps and adapter pan. Side rails are notched and pre-bent to
conform to your pickup bed.
1 1703482 Clamp w/Slot, Male
2 1115184 Clamp, Female, Lo Pro
3 1700429 Flat Washer, 3/8”
4 1700369 Cap Screw, 3/8” x 1 3/4”
5 1115745 Plastic Washer, 1/4” x 1 1/2”
6 1701580 Nylon Lock Nut, 3/8”
Item Part # Description
truxedo, inc.
P.O. Box 1078, 2209 Kellen Gross Dr., Yankton, South Dakota 57078
Call Toll Free: 1-877-TRUXEDO (1-877-878-9336) Fax: (605) 664-9304
Visit us online: http://www.truxedo
2
1
clamp assembly
4
3
5
6
___ 1 ___
STEP 1: A 1/4” x 6” piece of seal is provided to fill the gaps near
the bulkhead. This seal should be applied BEFORE
the side rails are attached. The following pictures
are shown with the side rails attached to illustrate the
proper placement of the seal. Cut seal to fit (approx.
4”) and place along the area marked by x’s in the photo
below.
bu
lk
he
ad
top view
rail
xxxxxxxx xxxxxxxxxxx
Add seal to areas
marked by x’s
gap
STEP 2: Cut another piece of seal and affix it to area marked
by x’s in the photo below.
xxxxxxxx
Add seal to
areas marked
by x’s
1/4” seal added
top view
side view
bu
lk
he
ad
rail
rail
bulkhead