Undercover Hidden Hinge Version - Manual (Page 4)

PAGE 4
Removal, Reinstallation & Wall Hanging Instructions
1
Minute
Removal
1
Minute
Re-Install
3 Easy Steps!
3 Easy Steps!
Wall Hanging Instructions
Step 1 - Release strut off of ball stud, be sure to
secure cover to prevent it from closing unex-
pectedly. Place loose end of strut in storage
clip. Repeat for other side.
Step 2 - Turn twist knobs until they release.
Step 3 - Pull tonneau cover rearward, releasing
hinge from mounting bracket, and lift the
cover off.
Step 1 - Place tonneau cover on the truck. Slide
the slots in the 4 bar hinges (attached to the
cover) over the posts on the front mounting
brackets.
Step 2 - Push the cover forward to lock the
hinges to the mounting brackets. Lift the cover
up from the rear and tighten the twist knobs
on both left and right hinges.
Step 3 - Re-install the struts.
Step 1 - Prior to removing the tonneau, mount
the two J-Hooks provided, on the garage wall.
The hooks must have a minimum height from
the floor of 84”. Center horizontally 32“ apart
from each other.
For long bed trucks mount 98” from floor.
Step 2 - Remove your tonneau from the truck
bed.
Step 3 - Hang the tonneau vertically on the
hooks, under side against the wall, inserting
the hooks into the holes provided.
Twist Knob
HYDRAULIC STRUT
(LARGE END)
ATTACHES TO COVER
(ROD END)
INCORRECT
PLACEMENT
OF FRONT FLAP
© 2012 UnderCover, Inc.
All rights reserved.
UnderCover, Inc.
P.O. Box 620
Rogersville, MO 65742