Unisteer 8011440 Full Size Ford 1960-1964 - Manual (Page 6)

Page 6 656160
11. You can now connect your outer ends to the steering arms. Knowing that your rack is centered your
front wheels need to be centered and as you connect the outer ends you can get your toe adjustment
close. Once they are close you can install the lock nuts provided. Also you may install the grease
fittings in the outer ends and fill with grease. With the wheels straight you can install the steering
wheel and torque to 35 ft lbs.
12. From under the car you can install the pressure and return line in place. The larger hose is the return
line and goes on the top port closest to the pinion. The smaller line is the pressure line and goes to
the lowest port on the rack. Route the lines up the frame in the shortest route to get to the new pump.
13. Your kit comes with a new pump and bracket. If your car had power assist you can remove the stock
pump and bracket from the engine. Your new bracket goes in the same place and uses the hardware
provided in the kit to install it. You will need to take a belt measurement around the pulleys and
purchase a new v-belt. If your car did not come with power assist you will need to purchase a crank
pulley from a Ford shop or an aftermarket company.
Return Port.
Large Hose.
Pressure Port.
Small Hose.