Unisteer 8052110 Corvette Shaft Kit 1963-1967 - Manual (Page 5)

Page 5 656270
6. Remove pinch bolt on column shaft. Remove dampening joint assembly from column.
7. From above vehicle, measure 2 3/8” from the end of the steering column shaft and make a mark on
shaft. Trim end of shaft off at 2 3/8” mark.
8. With rack centered in vehicle and steering wheel locked in the straight position, install intermediate
shaft assembly. Note: Inside of top u-joint should be flush with end of column shaft.
9. With upper u-joint on column with pinch bolt running across the flat on the shaft. Raise rack and
pinion assembly up in between the frame rails. Line lower u-joint up with the splines on the pinion.
Slide u-joint onto pinion.
2 3/8”