Unisteer 8010780-02 Chevelle Power Rack & Pinion Kit 1964-67 - Manual (Page 7)

pg. 7
655680
2. Next, route your lines from the remote reservoir to the return side of the pump and then out
the pressure side of the pump to the LOWER pressure port on the rack & from the UPPER
return port on the rack to the reservoir.
3. Top off power steering fluid and start car.
4. Check for leaks right away. If ok, turn wheels all the way right to left and hold for three
seconds in each direction. This will bleed air from the system.
5. After air is bled, top off fluid & install cap.
Your vehicle will need an alignment to reset your toe adjustment. It is best to see a pro
with the proper aligning equipment.
Alignment Specs:
Toe: 1/8 TOTAL (1/16 EACH SIDE)
Camber: ½ DEGREE NEGATIVE
Caster: 1 DEGREE POSITIVE +/- 1/2
UNISTEER
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
Last Revised 6/19/2014
Copyright © 2009 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying, recording or by any information storage
and retrieval system, with permission in writing from Maval Manufacturing Corporation.