Unisteer 8010660-01 MOPAR E-Body Rack & Pinion Kit - Manual (Page 6)

pg. 6
655660
To Mis-Phase the U-Joints, the Groove of the upper U- Joint must be aligned or rotated 45˚
away from the Groove of the lower U-joint as shown in the illustration below.
4) Reinstall the shaft with the U-Joints 45º out-of-phase, then tighten Pinch Bolts of U-Joints to 20
ft/lbs. Be sure to remember to tighten up the mounting hardware for the rack. Torque the
mounting bolts to 45 ft/lbs.
Pump Install
1. The pump assembly comes with brackets made to mount to the big and small block Mopar
motor, depending on the kit you ordered. Install the pump assembly to the motor as seen in
the illustrations. Use the 5.5” Bolt #231220 for the upper bolthole, with the spacer installed
this bolt is long enough that it threads into the rear bracket. Use the 4.5” Bolt #231210 for the
lower mounting hole. Tighten the mounting hardware to 35 ft/lbs.