Unisteer 8010400-02 Tri-Five Chevy Rack & Pinion Kit 1955-57 - Manual (Page 7)

pg. 7 655380
FIG 1 FIG 2
Pump connection
Since there are many different pump and bracket manufacturers it is virtually impossible for us to
cover all the installation steps.
Here are a few general things to follow. The pump you use should have a pressure rating of 800-
1,000 PSI, and a flow rating of 1.5-2 GPM (gallons per minute) flow rate. Keep in mind that this
low flow, low pressure pump will give the driver of the car the ease of power steering and
maintain good “road feel”.
Unisteer can provide a low-flow, low-pressure pump made specifically for your car(call for pricing
& details). Once the banjo fittings on the rack are in the position that you want, tighten them to 20
ft/lbs. The banjos can only be trusted not to leek after one time of tightening.
Make a mental note as to which port is the pressure & which port is the return (see illustration)
when attaching the steering lines & pump.
If you have any questions or problems regarding this product please contact:
UNISTEER
Performance Products
1555 Enterprise Parkway
Twinsburg OH 44087
800-338-9080
WWW.UNISTEER.COM
(01/15/07)
revised on 06/10/14
Copyright © 2009 by Maval Manufacturing Corporation All rights reserved.
No part of these materials can be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying, recording or by any information storage
and retrieval system, without permission in writing from Maval Manufacturing Corporation.