Unisteer 8012290-01 Ford Torino Small Block Rack Kit 1968-70 - Manual (Page 3)

Page 3 657220
Disassembly
The first step is to disassemble and remove the stock steering linkage, steering box and column.
1. Disconnect steering shaft from steering box at rag joint. Raise vehicle and support it on stands.
2. Remove the cotter pins and nuts from outer tie rod ends and remove tie rods from spindles.
Disconnect the center link, power cylinder, idler arm, hoses, and steering box assembly from the
frame and remove the entire old steering linkage system.