USG One-Directional Curvatura 3-D System - Manual

Parts and May include some or Installation videotape Bill of Materials (BOM)
Components all of the following:
Flush-Cut Main Tees for Termination Vault, Valley, and/or Straight Main Tee Segments
Main Tee Splices Termination Cross Tees
Stabilizer Bars 2 x 6 C urvatura One-Directional Panels
C urvatura Panel Joint Splices Edge Trim (if specified on BOM)
Edge Trim Fascia Splices Edge Trim Corner Clips C urvatura Wall Attachment Clip
(if specified on BOM) (if specified on BOM) (if specified on BOM)
Installation
Instructions
One-Directional
Curvatura
™
3-D System
Before beginning installation of the C urvatura One-Directional Ceiling System, check the enclosed bill of materials
to ensure that all parts and components are present and undamaged. Read all installation instructions first
and familiarize yourself with the system’s parts and components.
This is extremely important because parts will
become permanently damaged if they are installed incorrectly! To help with identification, all parts are poly-bagged
and labeled. Parts and components may include some or all of the following:
valley
vault
flush cut end
valley
vault
ID stamp
24"
23 3 / 4 "
72"
23"
vault
valley
PART LIST
A
A
B
B
C C
D
D
E
E
F
F
Page 1 of 12