USG Exterior Ceiling Applications Systems Guide - Manual (Page 38)

37 USG Exterior Ceiling Applications
USG Drywall Suspension System
Test Record UL526D
Class 60 Uplift
System Components
Main runners DGL26 or DGLW26
Cross Tees DGL224 or DGLW224
Perimeter Molding DGWM24 angle mold or DGCM27 channel mold.
When angle mold is used, main runners and cross tees attached to molding with 1/29 type S screws.
Gypsum Panels – Two layers of 5/8 in. thick, 4 ft wide gypsum board. Inner layer installed with long dimension perpendicular to
cross tees. End joints centered along cross tees. Side joints centered along main runners.
– Gypsum board fastened to each cross tee with no. 8, 1 in. long bugle head screws with one screw located at
midspan of cross tee and with additional screws spaced 12 in. o.c. beginning from center screw with screws
located 1-1/2 in. from gypsum board side joint. At butt ends, a total of seven screws used with one screw
located at midspan of cross tee and additional screws spaced 8 in. o.c. with one screw located 1-1/2 in. from
side joints. All screws located 1/2 in. from edge.
– End joints of adjacent sheets staggered min 4ft.
– Outer layer rotated 90 degree from inner layer and attached to cross tees and main runners through inner
layer using 1-5/8 in. long screws spaced 8 in. o.c. at butt ends. and 12 in. o.c. in the field. (Same spacing as
inner layer).
– Butt joints centered along main runners and staggered min 4 ft. Gypsum board attached to lower leg of wall
channel with fasteners spaced 12 in. o.c. for both layers.
Type Max Unbraced Length (in)
Compression Posts 3/49 x 1/29 x 0.0599 channel 28
3/49 x 1/29 x 0.0599 channel (Back-to-back) 46
1-1/29 x 7/329 x 0.0599 channel 31
1-1/29 x 7/329 x 0.0599 channel (Back-to-back) 41
3/49 EMT conduit, 0.049” wall thickness 59
1-5/89 25 gauge steel studs, 0.01799 min 61
1-5/89 25 gauge steel studs, 0.01799 min (Back-to-back) 76
– Back to back types shall be connected with stitch welds at 129 OC or with 1/49 dia bolts at 129 OC,
first connection within 69 of each end.
– Compression posts to be located within 6” of expansion joints if applicable.
– All compression post notched at ends to fit over bulb of main runner.
– Compression post fastened to main runners with type S coated steel screw or equivalent
– 33 ksi min steel.