UVP Automated BioLite - Manual (Page 9)

Automated BioLite MultiSpectral Light Source 9
7. Remove the rubber cap from the input side of the fiber optic trunk and plug the cable into the left
port on the BioLite unit.
Fiber Optic Light Table (Transilluminator) Installation
1. Remove one stopper at the left side of the darkroom.
2. If the imaging system already contains a transilluminator, unplug and remove the transilluminator.
3. Insert the fiber optic light table transilluminator in the imaging system.
4. Thread the knurled (non-smooth side) of the fiber optic cable from the inside of the darkroom
through the hole created by removing the stopper until the large bulb separating the smooth and
rough side of the fiber optic cable can no longer be pushed through the opening.
5. Remove the rubber cap from the input side of the fiber optic trunk and plug the cable into the left
port on the BioLite unit.
Plug the Fiber
Optic Cable into
the left port