UVP C-75 - Manual (Page 3)

Chromato-Vue Cabinets
3
Introduction
The UVP Chromato-Vue Viewing Cabinets provide a wide range of cabinet models and ultraviolet wavelength
configurations for use in laboratory or industrial applications. This Operations Manual covers the following cabinet
models: C-65, C-75, C-70G and C-71. These cabinets are designed for long life and rugged use in a wide range of
applications. The bottom panel of each cabinet is removable and the cabinet can be placed over samples or a
transilluminator. The lightweight access curtain allows for easy entry and blocks out external light. All cabinets are
manufactured of durable lightweight plastic. The view port combines a comfortable soft rubber, which can
accommodate eyeglasses, and a contrast control filter, which blocks the ultraviolet radiation.
The C-65 comes with a built-in white light. Ultraviolet lamps for use with this cabinet are purchased separately. Other
models mentioned above are fitted with ultraviolet light sources. Further information is provided below on each
model.
Operating Instructions
Materials shipped may include the following products wrapped individually: cabinet, eyepiece, bottom panel, and contrast
control filter. To remove shipping material from inside of cabinet, raise curtain by the lever on side of cabinet. Unwrap
bottom panel and insert into cabinet. The rolled edge of the panel should face down in front. Place unwrapped contrast
control filter into the open area on cabinet top. The unwrapped eyepiece should be placed over the rim of the cabinet
opening so that the nose notch faces forward.
Plug the power cord of the cabinet into a convenient wall receptacle. Cabinet is now ready for viewing.
Lamp control panel
is located at the top right of cabinet. Use the rocker switch for illumination control. If a transilluminator is to be used with
your Chromato-Vue Cabinet, remove the bottom panel from inside the cabinet and then place the cabinet over the
transilluminator.
Warning: Because of the potential ultraviolet radiation hazard inherent from the shortwave ultraviolet
models, please read Safety Precautions before using this equipment.
Features and Specifications
C-65 Chromato-Vue Cabinet
The C-65 Cabinet provides a built-in overhead white light. The ultraviolet light source is provided by the EL Series
Ultraviolet Lamps. Using two lamps gives even illumination from two sides of the cabinet. Each lamp utilizes 8-watt
dual bipin tubes. The lamp is plugged into the service outlet located on top of the cabinet and the lamp is placed over
the cabinet opening with the filter glass facing into the cabinet. A rocker switch is located on the back of the lamp for
lamp operation. The cabinet master ON/OFF rocker switch must be ON to operate the white light and service outlets.
See Accessories for optional equipment for use with the C-65.
Model Part Number Voltage
C-65 95-0257-01 115V, 60Hz, .9A max.
C-65 95-0257-02 230V, 50Hz, .80A max.
Cabinet dimensions
Exterior: 19.75”L x 16.5”W x 13.25”H (502 x 419 x 337mm)
Interior : 17”L x 14”W x 6”H (432 x 356 x 127mm)