UVP HM-4000 Multidizer - Manual (Page 7)

Hybridization Ovens
Page 7
Installing the Rollers and Optional Trays
To insert rollers in the hybridization oven carousel, slide the rollers into the receptacle on the left side of the chamber
first, followed by the right side.
To install the Reciprocating Shaker Tray (standard with the HM-4000), place the tray over the rollers in the
hybridization oven.
To install the Rocker Tray (optional on all units), remove the metal carousel from the chamber. Place the tray into the
chamber with the coupling arm to the right side. Place the coupling sleeve over the motor drive shaft such that the
pins on the inside of the coupling sleeve engage the slots in the motor drive shaft of the chamber. Rotate the sleeve
counter-clockwise 30° until locked in place. To remove the tray, reverse the process.
To install the Orbital Motion Tray (optional on all units), open the chamber door, remove the carousel, connect the
power cable to the orbital tray and to the power port inside the unit, and place the tray in the oven so the switch is
accessible. Turn the hybridization oven Motor and Power switches ON, and turn the orbital tray Power switch ON.
Reciprocating Shaker Tray
Rocker Tray Orbital Motion Tray