UVP iBox Explorer Imaging Microscope - Manual (Page 10)

iBox Explorer
2
10
Dichroic Splitter Cube Installation

The dichroic splitter cube is used
to direct coaxial lighting down
through the magnification
objectives while allowing sample
emission lighting to pass through
to the camera.

Slide the dichroic splitter cube door
open to the left (the door is
embossed with the UVP logo) and
fully insert the dichroic splitter
cube. Fully slide the door to the
right once the cube is in place.
Camera Assembly

The system will come shipped with the camera and objectives installed from the factory. No
additional assembly is required.
BioLite Xe MultiSpectral Light Source Setup
Note: Image shown may appear different from the product
shipped.

Position the BioLite Xe to the left of the darkroom,
turn off the unit and unplug the power cord.

The xenon bulb assembly will come separate from the
BioLite Xe and is equipped with a male connector on
one end and a female connector on the other.
CAUTION: Wear safety glasses when handling the
xenon bulb assembly! The bulb is under high
pressure and can explode if dropped or mishandled.

To insert the bulb, lay the BioLite Xe on its back so
that the bottom of the unit is exposed. Connect the
male connector from the bulb to the female connector
in the BioLite Xe and vice versa.
CAUTION: Do not touch the glass portion of the
xenon bulb assembly! Residual fingerprint oils can
cause the bulb to explode during use.

Connect the bulb base plate to the bottom of the unit
using the three supplied nuts.

Return the BioLite Xe to the upright position. Plug the
power cord into the receptacle on the back of the unit
and to a power outlet. Connect the USB cable to the
back of the unit and to the computer.
USB Cable
Power Cord
Dichroic splitter
cube door
Dichroic splitter
cube