UVP A-690 - Manual

See product literature for part numbers of Reveal additives, lamps and
injectors. Reveal is a trademark of UVP, LLC.
WARNING
KEEP ALL ADDITIVES OUT OF THE REACH OF CHILDREN.
MAYBE HARMFUL OR FATAL IF SWALLOWED.
http://www.uvp.com
UVP, LLC 2066 W. 11th Street
Upland, CA 91786-3509 / (800) 452-6788, (909) 946-3197
Fax: (909)946-3597 E-Mail: [email protected]
Ultra-Violet Products Ltd., Unit 1, Trinity Hall Farm Estate,
Nuffield Road, Cambridge CB4 1TG UK +44(0) 1223-420022
Fax: +44(0)1223-420561 / E-Mail: [email protected]
81-0126-01 Rev E
REVEAL ™ Plus
Leak Detection Additives
Instructions for use of the following additives from UVP:
 A-680Plus for Oil, Fuel and ATF Systems
 A-690Plus for Coolant Systems
 A-670Plus and A-671Plus for Air Conditioning Systems
 A-672Plus Universal A/C Dye
A-680Plus OIL, FUEL AND ATF ADDITIVE
A-690Plus WATER COOLANT ADDITIVE
A-680Plus is designed for instant location of leaks in automotive engines,
manual and automatic transmissions, power steering systems, and gasoline
and diesel fuel systems. A-690Plus is designed for instant location of leaks in
automotive cooling systems.
NOTE: NOT INTENDED FOR USE IN BRAKE FLUID SYSTEMS.
INSTRUCTIONS FOR USE
1. Dilution for A-680Plus is 1 oz. per 4 to 5 quarts of system fluid. Dilution
for A-690Plus is 1 oz. per 2 gallons of coolant. Pour 1 oz. of additive into
suspect system. To avoid the possibility of splashing, do not operate
engine while adding dye into the system.
2.
Run the engine for five to six minutes to circulate the dye. NOTE: For
some systems, it may be necessary to drive three or four miles to allow
sufficient circulation of the dye.
3.
Check for proper fluorescence by shining a blacklight on the system
dipstick or filler hole. NOTE: In some cases, it may be necessary to add
a second container of additive, ie: in dirty oil, graphite or molybdenum
sulfide based oils, or a crankcase greater than 5 quarts.