UVP Stable Ozone Generators - Manual (Page 3)

Stable Ozone Generator 3
Installation
For installation of SOG-1 and SOG-2, refer to Figure 1. For installation of SOG-3, refer to Figure 2.
1. Insert the light source into the port, position the lamp handle inside the port about 0.5 inches.
2. Tighten the set screw to hold the lamp in position.
3. Connect the flow gas unto one side of the quartz tube with the flexible plastic tube (not included; PTFE
recommended).
4. Connect the other quartz tube side as ozone output with the flexible plastic tube (not included; PTFE
recommended).
5. Connect the light source cable to the power supply.
6. Plug the power supply to the power source and turn the lamp on.
7. Adjust the shield length in order to produce the ozone concentration required.
8. Tighten the set screw to hold the shield into position.
9. Turn off the light source power once the task is completed.
Figure 1
Note: The light source housing is
assembled at the UVP factory.
Components are shown outside of the
housing to display connections. User
actually assembles inside the housing.








Light Source
Power Switch
Light Source
Housing