Vararam G8 Ram-AIR V User Manual
Page 3
Advertising
C. Lean the radiator back gently, just let it sit back without force.
D. Remove small rubber strip in front of radiator, this is where the VR scoop assembly will sit.
4. Now its time to begin Installing the VR system-
A. Start by Moving the wiring harness that is located on the backside of core support-just above the
rubber strip you just removed. This makes installing the VR system as one piece possible.
Simply unclip it on the left and on the right, just pull on the center clips. There is a center wire that is
usually wrapped with black tape, just unwrap the tap as shown. This allows more movement in the wire.
You will need to pull this up and out of the way as shown until the kit is completely installed in the car.
Advertising