Waring Pro WT400 - Manual (Page 4)

6 7
Single-Slice Toasting
If you are toasting a single slice of bread, set the heat
selector to a lighter setting than you normally would.
The toaster is designed to heat the whole toasting
chamber for two slices. By lowering the heat for a single
slice, you won’t overtoast.
Defrost Button
The Defrost button is designed to first defrost and then
toast the bread, which extends the toasting cycle.
The following breads and pastries should be warmed
using the Defrost button: frozen waffles, pancakes,
French toast, frozen bagels and toaster pastries.
Exercise caution with toaster pastries; the filling can
become quite hot, long before the surface of the
pastry becomes browned. Never leave toaster pastries
unattended while toasting or warming.
1. Insert slice(s) of bread, frozen waffles, pancakes,
French toast or frozen bagels. Be sure that multiple
slices do not overlap and the carriage is in the UP
position.
2. Press the carriage control lever until it locks into the
down position.
3. Turn browning control knob to desired setting from
light to dark.
4. Press the Defrost button with 10-second cycle time.
LED indicates feature is activated (if you press the
wrong function, simply press the button again to
cancel that function).
5. When the defrost cycle is completed the toaster will
raise the bread.
• Thickly cut pieces of bread (including bagels) will take
longer to toast, sometimes significantly longer, since
more moisture must be evaporated from the bread
before toasting can occur. Very thick pieces may
require two cycles.
• When toasting raisin or other fruit breads, remove any
loose raisins, etc. from the surface of the bread before
placing into the toaster. This will help prevent fruit
pieces from falling into the toaster or sticking on the
guide wires in the slot.
• Before toasting bagels, slice each bagel into two
equal halves.
To Toast
1. Insert slice(s) of bread.
Be sure that multiple slices do not overlap and
that the carriage is in the Up position.
2. Set the browning control.
Turn browning control knob to desired setting from
light to dark.
3. Press down carriage control lever.
Note: The carriage control lever will not stay down
unless the toaster is plugged in.
4. To stop toasting:
When the toasting cycle is finished, the toast
will be raised. If you wish to stop the cycle before
it is finished, simply turn the browning control
knob counterclockwise to cancel. Do not use
carriage control lever to cancel toasting.