Waring Pro WP55 - Manual (Page 5)

5
BEFORE FIRST USE
It is recommended to charge the wine preserver for at least 12
hours before first use. Please follow the instructions below to
charge the product:
This appliance is 120 volts only and should not be used with a
converter.
1. Take out the charging adapter and charging base. Insert
the charging adapter DC jack to the charging base (at back
of the base).
2. Place the wine preserver in the charging base, making
sure that it is firmly in position and fully engaged with the
charging base.
3. Insert the charging adapter into the power socket. The
charging light in the base will turn on to indicate the unit
is charging. It will take at least 12 hours to fully charge the
unit.
OPERATING INSTRUCTIONS
To vacuum-seal a partially empty bottle of wine:
1. Insert the stopper into the mouth of wine bottle, pushing
down until it fits firmly.
2. Set the date dial from 1 to 31, to mark the date wine was
sealed.
3. Position the wine preserver over the wine bottle and
stopper and push down gently, holding the preserver as
straight as possible.
4. When the sealing process is completed, the wine preserver
will automatically stop.
5. Remove the wine preserver and return it to the charging
base when done. This will protect and charge the unit while
not in use.
NOTE: Please hold the wine preserver as straight as possible. If
the position of the wine preserver is not straight/upright enough,
the wine preserver will not operate properly.
IMPORTANT: After a few days, the wine bottle may lose its full
vacuum seal. To keep it sealed properly, repeat the vacuum seal
process.