WarmlyYours TH115 -F-120GA - Manual

TH115 -F-120GA
Owners Guide
Buttons and symbols
On/Stand By Switch
Use this switch to put the thermostat in sleep mode
when its use is no longer required (e.g. summer).
This will not affect the clock programming.
GFCI Warning Light and Test Button
Day & Clock Settings
Programming Mode
Mode Selection/Exit Programming
Floor/Ambient (Amb. only with B)
Current Mode Auto, Manual, Vacation
Current Program Number
Setpoint definition/Pre-defined Setpoints
Increase/Decrease Temperature
TH115 Description
Align the bracket tabs on the control module with the
holes located on top of the power base.
NOTE: Keep the thermostat’s air vents clean and free
NOTE: The screw cannot be removed completely.
Control Module Installation
Power base
Control module
from obstructions.
F
Thank you for choosing the AubeTH115 a programmable
thermostat that provides both energy savings and comfort
When power is applied for the first
time, the LCD dispays: 0:00, MO
(Monday), and temperature of the
floor .
Press HOUR - MIN to set the
current time.
Press DAY to set current day.
For AF and F models: one of the two
LO : The floor temperature is below
32ºF (0ºC), or the temperature
sensor is defective, or not con-
nected.
The heating indicator i is dis-
played and the relay is closed
(energized).
HI : The floor temperature is above
140°F (60°C), or the tempea-
ture sensor is defective.
Correct
Incorrect
First Power ON
F
following messages may be displayed
if the installation is incorrect:
24/7 Installation Support • Lifetime Technical Assistance • Free Design Service • www.WarmlyYours.com • (800) 875-5285
10103-A 04/08