WarmlyYours JSR12 ET-End-Kit End Seal Ki - Manual (Page 3)

2
END SEAL KIT INSTALLATION INSTRUCTIONS
ET-END-KIT Installation Instructions ET-END-KIT
1. Score the outer jacket 2 in. from the
end of the cable. Remove the jacket to
expose the braid.
CAUTION: When removing the outer
jacket, be careful not to damage the
braid or the base cable insulation.
2. Push the braid back and cut ¾ in. off
the end of the base cable.
3. Slide the heat-shrink cap over the end
of the cable. Apply heat evenly until it
shrinks around the cable.
4. Pull the pushed-back braid over the
sealed end cap and twist the braid end
together.
5. Slide the 4 in. woven braid sleeving
over the end of the cable, allowing at
least ½ in. to extend past the end of
the cable.
6. Slide the 5-in. heat-shrink tube over
the woven braid piece, allowing ½ in.
to extend past the end of each end of
the woven sleeving.
7. Apply heat evenly to the heat shrink
tube until it shrinks around the cable.
8. While the shrink tubing is still hot,
gently squeeze the end of the shrink
tube with pliers and hold until cool.
The end must remain visibly sealed
when the pliers are removed. If the
tube does not remain sealed, then
repeat steps 7 and 8.