WarmlyYours JSR00 - Manual (Page 5)

4
10. Carefully shrink tubing by continuously
moving the heat source back and forth
to heat evenly. Be careful not to damage
heating cable.
11. Slide the green/yellow tube over braid
and heat evenly to shrink.
12. Center the 1-inch (25mm) black
shrinkable tube over the end of heating
cable as shown in Figure 12.
13. Evenly heat the black shrinkable tube
until it shrinks and adhesive fl ows out both
ends.
14. While tube is still hot, pinch the tube
with pliers, between the wires, and hold for
10 seconds to ensure seal. See Figures 14-1
and 14-2.
15. Slide parts in place as shown in
Figure 15.
16. For pipe protection, loosely attach the
metal pipe-mounting bracket to the pipe
with the metal band. Position the bracket
so that the cable and fi tting come straight
up and through the hole. Then, tighten the
band.
17. Use a metallic junction box to ensure a
proper grounding. Insert heating cable and
tighten.
NOTE: For ET-SR-240 heating cables, when
used in wet locations, follow instructions
provided with junction box to seal out water.
NOTE: Allow at least 6 in. of lead wire inside
an outlet box.
18. Make connections as shown in Figure 18.
Connect the power conductors to the cable
leads. Connect the incoming supply ground
to the cable braid and to the green ground
wire. The included wire nuts are not for use
with aluminum feed wires. The junction box
needs to be grounded.
19. For roof and gutter applications, put
warning label on junction box as shown in
Figure 19.
Power Connection Kit Installation Instructions (continued)
ET-PWR-END-KIT Installation Instructions ET-PWR-END-KIT